This works, but looks wrong from the debug in this version of code...can't tell if it's really working.


R7#sh run int s 1/0.2
Building configuration...

Current configuration : 208 bytes
!
interface Serial1/0.2 point-to-point
 ip address 180.40.7.161 255.255.255.224
 ip ospf network point-to-multipoint
 frame-relay priority-dlci-group 1 702 702 702 702
 frame-relay interface-dlci 702
end


R7#sh fram pvc 702

PVC Statistics for interface Serial1/0 (Frame Relay DTE)

DLCI = 702, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial1/0.2

  input pkts 33            output pkts 32           in bytes 4724
  out bytes 5819           dropped pkts 0           in pkts dropped 0
  out pkts dropped 0                out bytes dropped 0
  in FECN pkts 0           in BECN pkts 0           out FECN pkts 0
  out BECN pkts 0          in DE pkts 0             out DE pkts 0
  out bcast pkts 17        out bcast bytes 4140
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
  pvc create time 00:03:41, last time pvc status changed 00:03:41
  Priority DLCI Group 1, DLCI 702 (HIGH), DLCI 702 (MEDIUM)
  DLCI 702 (NORMAL), DLCI 702 (LOW)